Our Customers

• Municipalities
• Engineers
• Contractors
• End Users

• Online Design Form

• Back to Home Page

Contractors

CrystalStream Technologies has a lot to offer contractors. When costs are important, we deliver the most cost effective solutions available. When the job is specified to our product, the cost we quote includes much more than our device alone. It may not be important to you as a contractor that the design, engineering, and approval costs were built into the quote because, by the time you are on the job, those things have already been done. It probably will be important for you to know that we provide a site installation specialist who will come to your job to help you plan the installation, and who will be there the day of the installation to assist you.

You will not have to worry about specialized equipment to handle the unit. We will bring the crane truck and operator to lower the unit into place. You dig and level the hole and we will place the unit for you. You will also not have to worry about long delays for our installation. The base unit is fully assembled and operational upon arrival. If there is a riser, we will lower it onto the base and you will simply have to attach the pipes and backfill, just as with every other pipe structure on your site. That's all there is to it. Usually, we are off the site in under an hour.

We will help advise you during subsequent construction activities, to keep the unit clean and working properly, until it is time to turn it over to the site owner. You will have one additional benefit during construction. Our devices typically have over 500 gallons of hydrocarbon spill protection built in, so that an accidental fuel spill will be easily trapped in the unit. You can clean up on site, rather than down in a stream. Hopefully you will never need that protection, but you may need our local representative to answer questions or help you with a small problem. When you purchase our devices, you get our people, too.

If we are not specified on your job, and you want to take a look at our device because of its ease of installation and low cost, we will be glad to do so. There are a few things we will have to do, because we think it is only fair. First, we must contact the engineer or site designer shown on the plans. Even if they put "Or Equal" on the plans, they had specific reasons for using a certain device. We want to be sure that the engineer agrees that we are equal and is willing to help us with the second step, which is contacting the municipality that approved the drawings. We will submit details and calculations to them (at no cost to you or the owner) to support our substitution on the job. If the engineer and the municipality agree, we will gladly furnish you a unit. We do all this so that when your final inspection rolls around there will be no question about the approval of our device for your site.